Welcome to introduce Phase III of ALTITUDE, developed in collaboration with EigenLayer.

This phase empowers users of all backgrounds, whether experienced developers or newcomers to blockchain technology, to effortlessly launch a Flash Layer. Additionally, users can enhance the security of their Flash Layer by leveraging EigenLayer's restaking mechanism.

To complete the campaign, visit the Galxe page and carry out the tasks. Tasks one, two and three are off-chain, while four and five are on-chain.

This guide covers tasks four and five. Let’s get into it!

Task 4: Restake with EigenLayer
The minimal restake requirement is 0.01 Lido staked Ether or Rocket Pool Ether.

Get Lido staked ETH:

Open the wallet and click “Send”. Copy and paste the stETH token contract address “0x1643E812aE58766192Cf7D2Cf9567dF2C37e9B7F”.

Acknowledge the prompt by clicking "I Understand."

Input the desired swap amount and confirm the transaction.

Add the token address, 0x1643E812aE58766192Cf7D2Cf9567dF2C37e9B7F to the wallet to view the balance.

Get RocketPool ETH:

Visit https://testnet.rocketpool.net and connect wallet.

Proceed to stake the desired amount of Goerli ETH and confirm the transaction.

As a result, RocketPool Ether will be received in the wallet. Lastly, make sure to add the token “0x178E141a0E3b34152f73Ff610437A7bf9B83267A” to the wallet.

If there are any difficulties Staking ETH using Rocket Pool, swap Goerli ETH to RocketPool ETH on https://app.uniswap.org/#/swap using the token address “0x178E141a0E3b34152f73Ff610437A7bf9B83267A”

Restaking using the Eigenlayer Testnet

Go to https://goerli.eigenlayer.xyz, connect wallet, and choose either "Rocket Pool Ether" or "Lido Staked Ether" to proceed.

Restake a minimum of 0.01 Lido Staked Ether or Rocket Pool Ether.

Task 5: Launching a Restaking Trial flash layer

Visit AltLayer's rollup launchpad website prepared for Altitude Phase III

On the left tab, locate and click the "Create" button. This will display the Flash Layer tiers. Choose the "Restaking Trial" option and click the confirm button. A pop-up will appear.

Click "Proceed" to start creating the flash layer.

Note that each address can only create one restaking trial Flash Layer during the AltLayer Altitude campaign. This Flash Layer will last for 1 hour.

On the Restaking Trial setup page, input the Flash Layer name, scroll down to the bottom of the page and click the "Validate address ownership" button. Confirm and sign the message using the connected wallet.

To launch the flash layer, click the "Create" button.

The Deployment page will be displayed, showing the Flash Layer status as "Deploying".

Share the experience on Twitter by tagging Altlayer’s Twitter handle if you enjoyed using the Flash Layer and RAAS (Restaking as a Service).

Click the "More" button, then "Share" to easily edit and share the experience on Twitter.

Note:

     - If there is a recurring 429 error when creating the flash layer, click “Create” continuously until it is successful.

     - Proceed to share even if the flash layer has not finished deploying.

Check the Galxe page periodically until the tasks have successfully been verified.

And that’s it for Phase III of Altlayer! For more updates, follow us on all the social channels listed on our Link3 page.